The S2-3 is designed for driving two easyE-line actuators in parallel. Synchronization is achieved by adjusting actuator speed during operation.

If adjustment cannot compensate unbalance between actuators, the actuators will be stopped. This way mechanical stress and breakage can be avoided. Additionally the S2-3 includes current limiter and power stage temperature protection. S2-3 has adjustable start and stop ramps for smooth operation.

The basic control is done with Forward-, Backward-, and Stop-commands, either in continous mode or pulse mode.

Calibration input is for driving the system to its initial position. This is done with low speed.
A wide range of parameters can be altered to suit to different demands and applications.

The parameters are set with the handy interface S2-Prog or laptop pc to the Config- connector.


73 x 78 x 25mm
(Lenght x wide x heigh)
Picture is in the beginning of this page


(box version)
102 x 73 x 47mm
(Lenght x wide x heigh)
Picture is in the beginning of this page


(DIN-trail version)
Picture is in the beginning of this page


  • EEL-S2-PROGUSB programming cable for PC
  • Programming unit
  • Picture is in the beginning of this page


  • Synchronized parallel driving
  • Current and temperature protection
  • Settable drive speed
  • Adjustable start- and stop ramp
  • Different control modest
  • Wide range of parameters
  • Easy setting with serial interface
  • Good repeatability of settings
  • Autobalance feature


  • Supply Voltage: 12/24VDC, filtered less than 20% ripple
  • Output voltage = supply voltage
  • Quiescent current: 15mA
  • Motor current:: 2x10A cont. 2x20A, 25% duty
  • PWM frequency: 2kHz
  • Current limit: 1-20A
  • Temperature limit: 120°C (power stage)
  • Ramp times: 0-2 sek
  • Pulse input freq: max. 1kHz
  • Pulse inputs: up/down 10kO (Hi/Lo; 4-30V/0-1V)
  • Control inputst: 0-1V=OFF; 4-30V=ON (impedance 10kO)
  • Fault output: Active, pull down max.50mA
  • Aux. voltage output: 5V/20mA
  • Dimensions: 78 x 73 x 25mm
  • Operating temperature range: -20° - 60°C
  • Weight: 110g
  • CE: Electromagnetic compatibility, Industrial Environment